Description
The TM1 PLUS is a 6 mm pre-polarized condenser microphone used for test and measurement applications. The TM1 PLUS is known for its linearity, accurate response, consistency, ease of use and affordability.
Characterized with a uniformly controlled omni-directional polar pattern, the TM1 PLUS is designed to capture acoustic measurements for room analysis software programs, real time analyzers and other sound control devices. With a flat frequency range of 20 Hz – 25 kHz, the TM1 is an excellent tool for sound engineers, sound companies, and recording enthusiasts.
Requiring 18 - 52 Volts phantom power for operation, the TM1 features a precision machined 4-stage brass body and capsule housing, nickel plate finish, Switchcraft ® or Audix XLR, shock absorbent O-rings, and heavy duty snap to fit mic clip.
The TM1 PLUS is designed, machined, assembled and tested by Audix in the USA.
Features
- 6mm pre-polarized condenser capsule
- Hi SPL response
- Precision machined brass housings
- Low noise electronics
- Replaceable electronics and capsule
- 3 year warranty
Applications
- Test and measurement
- Real time analyzers
- Room analysis software programs
- Ambient room miking
Supplied Accessories
- Shockmount clip
- Carrying pouch
- Threaded windscreen
- Calibration data & sensitivity measurement on CD
- 1/2" calibrator adaptor
Specifications
Frequency Response 20 Hz - 25 kHz +/-2dB
Polar Pattern Omni
Output Impedance 200 ohms
Nominal Sensitivity 6 mV / Pa @ 1k
Maximum SPL 130 dB with distortion < 1% 140 dB Max
Signal to Noise Ratio 66 dB
Equivalent Noise Level 28 dB (A weighted)
Dynamic Range 112 dB
Power Requirements 18-52 Volts phantom
Connector male XLR
Polarity Positive pressure on diaphragm produces positive voltage on pin 2 relative to pin 3 of output XLR connector
Housing 4 piece precision machined brass
Finish Nickel
Length 150 mm / 5.9 inches
