Description
Merit M-8S Power Sequencer is the perfect low-cost AC power solution for any rack mount system. Install an M-8S in your rack, and the eight outlets in the rear panel will power up in sequence and protect all your equipment up to a 15-amp load.
Features
- Standard level AC protection and filtering
- Six sequenced rear panel outlets (in 3 groups), two unswitched rear panel outlets, and one front panel unswitched outlet
- Momentary and Maintained sequencing via rear panel terminal block or front panel switch (momentary only)
- All settings and configurations available on rear panel
- Three year limited warranty
- Prevents excessive inrush currents
- Noise filtering to reduce radio frequency and electromagnetic interference
- Ensures equipment stays safe
- Eight rear panel outlets and one front panel convenience panel outlet
- 15 amp rating, with circuit breaker
- Front panel indicator LEDs for Outlet Banks, Protection OK and Power Status
- Rear outlets have been spaced to accommodate even the bulkiest of wall warts and adapters
Specifications
Maximum Output Current: 15 amps, 120 VAC (Thermal breaker)
Line Cord: 14AWGx3, 10 feet, black, fixed, NEMA 5-15P plug
AC Receptacles
- Convenience Outlet (Front Panel) 1 Un-switched NEMA 15-5R
- Rear Panel Outlets: 2 Un-switched NEMA 5-15R (1 duplex),
- 6 Sequenced NEMA 5-15R (3 duplexes, each controlled by separate relay)
Standard level AC Surge Protection: Merit Class (sacrificial)
Spike Protection Mode: Line to neutral, zero ground leakage
Max Continuous Operating Voltage: 130V RMS
Max Clamp Voltage: 500 Volts Peak
Peak Impulse Current: 12,000 Amps
Energy Rating (2 X 820μS): 225 Joules
AC Filtering: Standard level Pi LCR Filter
Noise Attenuation: >26dB, 100 Khz to 1 MHz
Operating Temperature Range: 5C (40F) to 40C (105F) degrees
Humidity Range: <90% rH (Relative Humidity)
Rocker Switch: Front panel, Sequence (ON, OFF)
Thermal Circuit Breaker: Front panel, push to reset
Front Panel Indicators: Delay 1, Delay 2, Delay 3, Power, Protection OK
Rear Panel DIP Switches: 12V Mode On/Off, GND Mode On, Momentary/Maintained
Potentiometer: Rear panel, time calibration fine tune delay adjust
Remote Terminal: +5-30VDC In, 12VDC (12mA) Out
Remote Terminal: Phoenix type 4-Pin Connector with Screw terminals; +12V, STAT, REM, GND (Class 2 Wiring)
Dimensions: 19"L x 8.75"D x 1.75"H – ANSI 1RU
Weight: 7 lbs.
Power Consumption: 5 Watts
Safety Agency: C/CSA/US 15 amps, 120 VAC (Thermal breaker)
